Show 'Em Off!
#5566
To be fair, it is the other side of the truck, so the bumper could be mis-aligned from left to right. And the valance tucks under a lot more when you look at it from behind the front wheel versus bang-on or from the front because you can't see the very bottom, which curves a lot.
It does look like the lower valance was cut straight out though, because it doesn't turn to start forming a semi-circle, but that could be the difference in angles like I said above.
Just looking at it, the truck looks high enough to clear them cause it's so damn big.
It does look like the lower valance was cut straight out though, because it doesn't turn to start forming a semi-circle, but that could be the difference in angles like I said above.
Just looking at it, the truck looks high enough to clear them cause it's so damn big.
Last edited by KMAC0694; 05-02-2014 at 11:21 PM.
#5568
#5569
Thanks! I practically stole it.
And oh yes I can relate to that, I had a 97 F350 OBS with the 7.3. 6" lift, 35s, and about 10k into the motor, head studs, injectors, HPOPS, intercooler, efuel, bigger turbo, full BTS tranny. Rolled it. Like an @sshole. Not a day goes by that I dont miss Leroy...
And oh yes I can relate to that, I had a 97 F350 OBS with the 7.3. 6" lift, 35s, and about 10k into the motor, head studs, injectors, HPOPS, intercooler, efuel, bigger turbo, full BTS tranny. Rolled it. Like an @sshole. Not a day goes by that I dont miss Leroy...
Last edited by WilliamWallace; 05-03-2014 at 12:42 AM.
#5570
#5571
Oh no doubt. Heres a few pictures of her, dont wanna mud up this thread with bad@*** 1 ton pics haha
https://www.f150online.com/forums/in...-guy-here.html
https://www.f150online.com/forums/in...-guy-here.html
#5572
#5574
#5575
I know it's from the movie haha that's why I asked if you were. I'm Scottish though and it's one of my favorite movies (should be up there on everyone's list in my opinion), so I love the name!
#5576
well the pad doesn't sit under it for the most part anyway, there's that little lip and it meets up with the grille around then. they all stick out, to me it just looks cut.. the edges aren't even smooth anymore
this is true, the edges look cut and they don't line up. but who am i to say, looking at pics it looks cut, but if he says it isn't guess it isn't...
![Dead Horse](https://www.f150online.com/forums/images/smilies/DeadHorse.gif)
![Frown](https://www.f150online.com/forums/images/smilies/frown.gif)
this is true, the edges look cut and they don't line up. but who am i to say, looking at pics it looks cut, but if he says it isn't guess it isn't...
![Dead Horse](https://www.f150online.com/forums/images/smilies/DeadHorse.gif)
![Dead Horse](https://www.f150online.com/forums/images/smilies/DeadHorse.gif)
![Frown](https://www.f150online.com/forums/images/smilies/frown.gif)
the bumper is pushed out because of the body lift relocation brackets for the bumpers
![lurk](https://www.f150online.com/forums/images/smilies/lurk.gif)
#5577
#5578
If so, I actually just installed a factory handle with the keypad in my truck because the trucks are set up for it.
#5579