Your truck will look sweet once its done, I am sure, and you better post some pics!! It sucks to hear about the ball joints only lasting 20,000-25,000 miles, But at least with me I won't have this truck that long, since I only put on about 5000 mile a year on this truck. And I don't plan on keeping it for more than 3-4 years, I geuss that it will be someone elses problem

 

Sorry i wasn't on yesterday. Busy with the lift until all hours of the night. The hardest part was those damn compression struts and the rear leafs. I couldn't take the leaf packs out of the truck without removing the gas tank. So i did the aal in the truck.

Thumper i don't off road my truck alot maybe like 1 or 2 times a year.

Difficulty from 1-10 i would say about a 8 with one person and maybe like 5 if you had 2. It was actually alot easier than i expected.

I am uploading pics right now so give me a couple mins.

 

Here is the pics. I know the truck is a bit dirty. I am gonna clean her up and get some good pics tommorow. But here is some for now. I don't know why the back looks lower in some pics. Must be my driveway. I couldn't imagine how low it would be without the aal. I did measure it though. It's 46" from the ground to the fender lip on the front and 48" on the back.










Now once i get some good pics who wants to make me a new sig

 

looks good man

 

looks real nice!
how is the ride difference?

 

It actually rides better in the rear than from factory. The front is the same.

 

It looks great!! Nice job! Can you tell how much the lift increased your front track width?

 

The lift didn't increase my track width at all. I actually left the half shafts on the diff when i did the lift.

 

Sweet! I could have sworn that an article I read on the Pro Comp lift back in 2004 said it increased the front track with a couple of inches. Maybe it was the Fabtech lift.

 

Fabtech increases 3/4" on both sides.

 

hey thump, how does fabtech compensate for the gap?

 

My track width increased about 3/4 on both sides. And I have the procomp kit also.

 

Maybe because 2wd? I didn't put any spacers on my half shafts so it couldn't have increased any.

I know that the fabtech kit will increase the track width 1.5" though.

 

That's one sweet looking lift. That AAL made all the difference. No sag-***! It looks great dude.

 

I'm jealous....

Looks sweet