Several months ago, I know there was a thread going around about front & rear wheel-well covers from our trucks. At that time, I think the consensus was that nobody made them yet, but there were a few out there that could be modified to fit.

Just wondering if anyone has an update to this. Does anyone make them specifically for our trucks yet, front & rear? 2wd, if that matters.

 

They are a friggin pain to deal with, I removed mine to install my e-fans. I only got one back in perfectly, the other I left out for a few reasons. I'd like them in the rear as well to make mudding a little easier to clean.

 

yeah i used to have them in the rear of my 04 ram it was a pleasure to clean and looked nicer too.

 

This is definitely one of those things that FoMoCo snubbed to save a penny or two...

Like most here, I found them to be VERY beneficial...

 

I have read some posts where a few folks have ordered the front liners and modified them to fit the rear fenders. If you really wanted liners you could go that route.

 

If it's a matter of the actual wheel well, a Line-X type of spray may be useful. As for wheel well gap guards, check out the following thread for more info. No, I do not have either of these mods on my truck.

https://www.f150online.com/forums/sh...ght=wheel+well