I installed a set of 1 inch rear blocks on my truck this afternoon and noticed that the bottom u-bolt carriage is not exactly at the 6:00 position. It is more at the 6:30-45 position. It should be ok right?

Thanks in advance,
#16F150

Here are some pix...

Left
http://www.flickr.com/photos/dseg5298/4994178749/
Left up-close
http://www.flickr.com/photos/dseg5298/4994178913/
Right
http://www.flickr.com/photos/dseg5298/4994178989/

 

I have never looked at these specific blocks. Are they angled on one side? That could explain it. I would think that the way they are sitting is incorrect. I would also think that would throw your pinion factor way out. Not sure though...

I know that didn’t help much.
Good Luck
Andy

 

to tell you IMO i think they are supposed to sit at 6 oclock not on any kinda of angle as i have never seen them sit on an agle b4

 

Yeah I was able to straighten them out yesterday. I put them back to exactly where they were before. Plus now I won't constantly think about it, thanks for the input guys... I will post updated pics this weekend

#16F150

 

yeah thats not right but you already fixed it so good job

 

why thank you sir, now I won't be driving around thinking that my rearend is going to fall off, LOL