Hey guys, I have an 10' FX4 Super Crew With Out the premium sound (mistake). I want to upgrade my sound, keep my sync, and factory look. This is what I got so far.

I ordered the interior "A" pillars w/the tweeter cut out from Tusca. I want it to look factory.
9L3Z1503598GA - Passenger
9L3Z1503599GA - Driver
About $180 after shipping and tax.

Useing the Kicker ZXSUM8 as a signal processor.
Alpine PDX5 - 4channel + 1 Mono. 75w RMS x 4 @4ohms and 300w RMS x 1
Type R SPR-17S 6.5 component speakers for the front
Type R SPR-57C 5x7 coax speakers for the rear
1 Kicker CompVT 10" subwoofer

These are my questions.

I've hooked up subs to factory stuff using a line out converter but never used a sound processor before. Does anyone have any experience? How do you wire it in?

Does anyone have a wiring diagram for the 2010 F150 w/o premium sound?

Any other advice, or things I'm missing?

Again, I'm not trying to blow my doors off, just want it to sound good. Let me know what you think. Thanks.

-Cesar

 

I realize that this was posted a LONG time ago, but for some of the other guys who are looking for this same thing (as I was at one point), I figured I would respond ......

So in response to the original post .......

Not sure if this is what you will be looking for, but I found a link that helped me out with my basic speaker install and has different wiring diagrams for the different factory radio options offered by Ford.

I hope at the very least it helps someone out!


http://www.intyss.com/downloads/2010F150AUDIO.pdf