I am new to this forum so forgive me it this has already been asked. I am going to be getting a 2011 F150 XLT screw 6.5 foot bed 4x4 5.0 as a gift for making Eagle Scout. I don't know if this will effect y'alls decision but it will be leveled and have 3 inch blocks. I am going to be getting a Magnaflow Magnapack and preferably 5 inch angle cut rolled end polished tip. I can't decide if it should go out before the rear tire or below the bumper coner (6.2 super duty style). Any ideas? Please post pics as well if you have them.

 

What the heck is Eagle Scout?

 

Its the highest you can go in Boy Scouts. Usually do it when your younger and proceed at your rate and age.

 

Here is a picture of mine that comes out on both sides between the rear tire and the bumper. I like it. Hope it helps your decision.

 

Just another option..... my personal preference.

 

Are you kidding me? A truck for making Eagle Scout lmfao give me a break. I got nothing, but a "good job."

 

I agree with you for sure. I was same way when I got my eagle scout. Good job and keep up the good work. All I have to say is someone has more $$ than they know what to do with and the other is very spoiled. Sure must be nice!

 

$40,000 present. Awesome. Wish I had that when I was your age. I had a 1983 Camaro.

 

5 inch tip on a F150? thats kinda big, You don't have a diesel motor in that truck stick with a 3 at most 4" tip

 

congrats on getting eagle scout what did you do for your eagle scout project?

my favorite set up at the moment is either dumped or 45's out the rear bumper with a 3.5" tip.

 

My Banks has 6"x5" tip. I think it looks filling.

 

You have a picture? I don't see the need to run a big tip on a F150 but with some visual i might like it.

 

I've got 5" tip dumped after the rear axle

 

Center Dump?

 

^^ his actually came out good on his, but i think it's only due to the lift and tire size on the truck. no way a stock truck could come close to pulling it off.