Would this work?
#2
02-07-2003 | 06:53 PM
Senior Member
Joined: Oct 2002
Posts: 812
Likes: 0
From: R
If you are going to get a DI/DO there is no need for the X-pipe becuase that muffler has a built in crossover. Other than that just run the piping however you want with some nice stainless steel tips and you'll be good to go!!! Sound will be mellow at idle and sound great when you stomp on it.
#3
02-07-2003 | 09:22 PM
Senior Member
Joined: Oct 2002
Posts: 5,358
Likes: 1
From: Commerce Twp, MI
It would work. I have no idea how much performance you would get or lose, but it would work. The MAgnaflow has some kind of crossover, but I have heard H-pipe and x-pipe. I have not seen one so I cannot comment on the quality of the crossover. If I were willing to us an external x-pipe, I'd go with two smaller 2.5" SISO mufflers.
#4
02-08-2003 | 01:53 AM
Technical Article Contributor
Joined: Jun 2002
Posts: 10,511
Likes: 7
From: Under the flightpath of old ORD 22R
The internal cross over is not the same as the X pipe.
If you want to go true duals, go with the external X pipe and 2 SI/SO mufflers, then finish it to taste ( side dump, rear side dump, straight out the back, etc ).
If you takng the time and cost to put in the X pipe, go dual mufflers also. You won't be sorry for this mod !
If you want to go true duals, go with the external X pipe and 2 SI/SO mufflers, then finish it to taste ( side dump, rear side dump, straight out the back, etc ).
If you takng the time and cost to put in the X pipe, go dual mufflers also. You won't be sorry for this mod !