ok so i have a stock exhaust system im looking for a cheap way to make it loud with out much labor, is my best bet cutting out my muffler, and i dont want to mess with my cats, thanks

 

just chop that thing off. takes like 10 seconds with a sawz all

 

its not WAY to loud and is it a good powerful sound

 

Its not that loud, but the drone in the cab gets sooo annoying, you can't even think after a long drive, all i heard was the drone in my head. My setup is quite loud and ran me $120, the vids are in my sig.

 

haha its nice i already saw that on youtube how small of a world is this

 

It has been my 5th exhaust, I started with Flow si/do, changed it up, went to a dump with the flow, single dump, true dual dumps and finally this, I like it the best of any so far, and get the most compliments with it. Sounds great bouncing off of cars as I go by. It is still loud in the cab, but doesn't rattle the the dash or my head like any of the dumps did.

 

im not planning on dumping but thanks

 

Chop off your Y-pipe as close to the Rear o2's as you can and have True duals with all 4 of your cats and all 4 of your o2s working normaly!! i ran this for about a year after the Y-pipe with just the muffler gone made me mad when itd shifted itd make a funny noise...Choped off the Y-pipe Much better sound and no more funny noise!. cut as close to the Rear o2s as you can and ull be set

 

rear o2s???

 

Did you have it dumped or coming out the back?

just wondering if sending the pipe though the back will help with the drone?

 

It was dumped, what are you thinking for your setup?

 

They are behide the cat right about were the crossmember is. They tell the computer that the Cats are working. and doing what they should. i just cut my Y-pipe as close to the o2's as i could then i put turn downs over it so i didnt have black stuff all under my truck sounded good...and it was CHEAP!!

 

im just taken off a conector pipe about 3 feet up the pipe from my muffler, no sawing

 

Im thinking to take out the muffler and put a straight pipe in its place, so that the sounds coming out the back

 

I love the sound of my 5.4 with no muffler! All I did was cut the muffler out, removed all of the piping behind my muffler and then went to autozone and bought a turn down tip, pointed it toward the side of the truck and clamped er' on! Cost all of 15 bucks and sounds absolutely amazing!