Heim joint help needed
#16
Originally posted by Ruslow
Tim what yo need is made by a company that markets seal ends under 'seals it' on the bar there should already be one set.As for using teflon that works but you still have the dirt getting into the joint and wearing it out.The sels it s' come in sizes from 1/4 to 3/4 but there is no way to lube them just seals the end.Stan
Tim what yo need is made by a company that markets seal ends under 'seals it' on the bar there should already be one set.As for using teflon that works but you still have the dirt getting into the joint and wearing it out.The sels it s' come in sizes from 1/4 to 3/4 but there is no way to lube them just seals the end.Stan
I can then add some neoprene washers where the outside edge of the heim clicks against other hard parts.
The replacement bar you sent had the same joints on both ends, whereas the original bar had a seal on one of the joints, the diff end, I think. Thanks, Stan.
#17
Originally posted by Rob_02Lightning
Tim, that is a hot set-up
Tim, that is a hot set-up
Last edited by Tim Skelton; 01-21-2003 at 10:43 AM.
#18
#20