Built longblock is done!!!!!!!!
#1
Built longblock is done!!!!!!!!
My motor is getting shipped out on December 1st. Here is a list of stuff that went into the motor. I am gonna try 16#s on a ported Eaton and a 125 shot to cool it down. Good times are in my future.
Race prepped 02' Lightning block (square decked,line bored,torque plate honed,deburred)
Ford forged steel 02' take out crank,polished,chamfered,balanced)
CP 17cc dish pistons 3.572" bore,.866" tool steel pins,spiro locks
Scat H-beam rods with ARP 2000 series bolts
Federal mogul race bearings(rod and main)standard
New Ford oil pump
ARP head and main studs
Modmax stage 2 cams
Ford followers
Ford lifters
Ford valvetrain
PI castings w/ 5 angle valve job fully assembled
Race prepped 02' Lightning block (square decked,line bored,torque plate honed,deburred)
Ford forged steel 02' take out crank,polished,chamfered,balanced)
CP 17cc dish pistons 3.572" bore,.866" tool steel pins,spiro locks
Scat H-beam rods with ARP 2000 series bolts
Federal mogul race bearings(rod and main)standard
New Ford oil pump
ARP head and main studs
Modmax stage 2 cams
Ford followers
Ford lifters
Ford valvetrain
PI castings w/ 5 angle valve job fully assembled