OK gus, I'm ready for some more HP, any tips??
#1
OK gus, I'm ready for some more HP, any tips??
I have the FTVB, oil seperator, BBP,JLP Ram air CAI, #4 pulley and a Predator tuned by Sal at PSP. On the dyno in 85 degree weather I put down SAE 382HP and 482.6 TQ. I'm thinking the next step is electric fan kit and ported eaton done by Apton?? I wanting to get it NEAR the limit of what the bottom end can handle. Not over the limit to where I blow the bottom end out of it. Whatcha think??
#2
I have the exact same mods as you plus the Apten and E-fan. Without the E-fan I made 400hp SAE in 90 degree temps. 'Course since that dyno run I also had JLP dyno tune my truck so I'm probably at about 405-410hp and 490-500ftlb. I don't have the exact numbers because it was on a mustang dyno compared to my dynojet numbers. I would recommend both and you should be just fine as far as your block is concerned. I'm even wanting to get a 75-100 shot on top of that for those track days
Last edited by ~nightcrawler~; 08-05-2004 at 12:43 AM.
#3