Hey All!!!

I have some new pending mods. I'm thinking of going with a Skyjacker 6" lift system, 35x12.5/17 mickey thompson baja claw radials, and 17x10 weld racing rims. I'm wondering what kind of gears I should go with, there so many out there, anyone have any good advice?

 

i would go with 4.56 or 4.88 for that added low end grunt, genuin gear makes both these sizes and it is what i have used in my F-150 with no problems, self installed and i get no or very little off throttle wine, wich is common with the lower (higher numericly) gears, good luck

 

First one hella truck! and thanks for the info.

 

thanks, and no problem you need any more help let me know i have done a few ring and pinions and i have some tips if you can do it yourself

 

great thanks! I probably will.

 

no problem just let me know

 

I just put 4.56 gears in my f150 with 35" procomps. It is a much better improvement starting off the line. 4.56 will bring you back more closely to what the stock ratio would have been. just make sure you don't go to big.. i have heard of people get some driveshaft vibration but personnally i haven't gotten that. Typically happens when you have smaller tires then get say 4.56 gears on 30" tires. hope this helps alittle