Procomp 6"
moto metal 951
18x9
4.53" backspacing
35x12.5x 18

will my tires stick out?
if so how much?
i would like to keep my tires as close to flush with the wheel wells as possible. What Backspace would you recommend for that and will it cause alot of rubbing?

Thanx in advance, getting my lift wed. need to figure this out asap.

Oh ya it's on a 2007 f150 crew cab 4x2

 

well look at it this way. The tires are about 2.5" wider than stock and that rim will push thim out an extra inch, so you are looking at being about 3.5inches further out than your current setup.

 

my wheels are 9" wide and same backspacing.

 

If you want your wheels close in you are going to have to get the ones with the 6in of back spacing. Also take into consideration that your rim is going to look flat now. You will be loosing all of the rim dish.

 

A 9 inch wide wheel with 4.5 inches of backspacing is gonna stick out 2.5 inches farther than the OEM wheels. Another thing to consider is whether or not the Pro Comp kit increases the front track width. I don't think it does, but I'm not positive.

 

I've read that pro-comp 6 inch kit extend the tracks by 3 inches...

 

The tires will stick out.. But it can be fixed with fender flares..

 

I have the 4.53" BS on mine, but that was the look I wanted. I like them to stick out. It all depends on what you like.

 

Dosesn't Fabtech recomend no more than 5" of BS? What happens with a 6" or more bs?

 

Probably interference with the knuckles.

 

it will stick out a bit. it looks nice either way i think.

check mine out, i got moto metals 951s

https://www.f150online.com/galleries....cfm?gnum=9417

 

Here you go. .