I'm tearing into my project tomorrow morning and wanted to get a couple more questions out there.

I either have or have bought tourque wrench, 30 mm socket, 1 1/16" wrench, 4 pound sledge (biggest I could find arround here with a short handle), and the other socket I think 21 mm. I do have a compressor and impact wrench. Also have a small hydrolic (sp?) lift and jackstands. Anything else other than normal tools that I might need to get this done?

Also if anyone has done the 1 1/2" Autospring REAR lift themselves I'd love to hear any tips, tricks, heads up, etc... on that. Havn't seen much on them here except that a few have them.

I hope this is as easy as people say it is.