Before level kit measurements
#1
08-12-2009 | 02:12 PM
Thread Starter
|
Member
Joined: Nov 2006
Posts: 86
Likes: 0
From: South Arkansas
Before level kit measurements
I posted this in another thread and it may have gotten lost. These are my before lift measurements and I'm puzzled as to why they are off on the wheel wells but even on the bumper.
My measurements weird from ground to center of fender. They are off by about .5" on the right side, BUT the bumper is measuring the same from side to side. Keep in mind that I have bald 275/70R18 Maxxis Bighorns on now that were about 33.2" new, and the factory 1.5" block in the rear.
Driver front: 37.5"
Driver rear: 40.95"
Passenger front: 37"
Passenger rear: 40.5"
Driver side rear bumper: 32"
Passender side rear bumper: 32"
Those were in my parking lot at work. I measured last night in my gravel drive and they were off even more, but the ground was not level since it was gravel. Also, the bumper was level at that time, too.
My measurements weird from ground to center of fender. They are off by about .5" on the right side, BUT the bumper is measuring the same from side to side. Keep in mind that I have bald 275/70R18 Maxxis Bighorns on now that were about 33.2" new, and the factory 1.5" block in the rear.
Driver front: 37.5"
Driver rear: 40.95"
Passenger front: 37"
Passenger rear: 40.5"
Driver side rear bumper: 32"
Passender side rear bumper: 32"
Those were in my parking lot at work. I measured last night in my gravel drive and they were off even more, but the ground was not level since it was gravel. Also, the bumper was level at that time, too.