Finally got some pics

Old vs new tires:



about to do the alignment...this angle makes the front look higher then the rear...it's just the camera angle though:



Rear wheel with exhaust:



Still inside the fender:

 

Final Product:

 

double post sorry..

 

What size level did you get?

Did you happen to measure your AS before putting it in?
Just curious as to what it actually measured.

 

Nice truck davewvu86!

FX4Screwdude, I got a AS 2.5" truck sits 38 in front and 38 in back. Couldn't be happier!

 

Uh...can you smell it? That smells like sweet fow show!
Enjoy your truck!

 

They look great!

 

IIRC, the rake on mine was just about 2.5" on a slightly uneven surface. Never got around to measuring it on a flat surface and haven't yet measured it since doing the kit. Couldn't find a tape measure when I had it up on the rack in the shop.

The rake looks to be close to an inch now which works for me because I tow my 26' boat and other things on a frequent basis and I don't want the rear end to sag. I didn't get a chance to measure the units themselves before I put them it, but I'd say they were about an 1.5" tall and yielded perhaps a hair under 2" of lift. They were also slighly offset. I'm assuming to help with the ball joints.

Best of all, the truck still fits in the garrage

If I wasn't planning a wedding in 2 months about about to take on $50k a year in debt for school I'd be looking into a CAI and Edge...I wish I could find more $79.99 mods that are as rewarding!!!!

 

Alllllright just measured it. The front is at 39 1/4" and the rear about 39 7/8"

 

Sweet!

 

I have the 1.5" AS and 295/70/17s on my '05 screw. It's the PERFECT combination for me. It looks great too. The 1.5" is just the right size. I have to get some better pics, but there's a few in my gallery.