Advice on fender trimming?
#1
Advice on fender trimming?
I'm running 33x12.5x20 Toyo MT tires on 20x10 Moto metal 951 with -18mm offset and 4.79" backspacing.
I have a pretty bad rub that doesn't allow me to get any more than a half turn in reverse.
Looking at the area where it rubs i may have to cut some of the body for it not to rub at all.
Anyone have some advice or opinion on this? I'm not sure if I should find a body shop to do this or not even bother and get an 18" rim with a smaller offset and backspacing.
My truck is a 2wd and has a 3" readylift leveling kit.
I have a pretty bad rub that doesn't allow me to get any more than a half turn in reverse.
Looking at the area where it rubs i may have to cut some of the body for it not to rub at all.
Anyone have some advice or opinion on this? I'm not sure if I should find a body shop to do this or not even bother and get an 18" rim with a smaller offset and backspacing.
My truck is a 2wd and has a 3" readylift leveling kit.
![](http://img225.imageshack.us/img225/2285/wp000068n.jpg)
#2
#3
#4
well I want the width.
I said 18" rims because the 18x9 moto metals have -12mm offset and 4.53" backspacing (or something close to that) instead of my -18mm offset and 4.79"
That'll give me about .5" less width and a little less rub, maybe enough to only have to cut fender plastic and no body.
I love the width.
I said 18" rims because the 18x9 moto metals have -12mm offset and 4.53" backspacing (or something close to that) instead of my -18mm offset and 4.79"
That'll give me about .5" less width and a little less rub, maybe enough to only have to cut fender plastic and no body.
I love the width.
![](http://img838.imageshack.us/img838/4312/wp000167.jpg)
Last edited by BroBro; 06-10-2011 at 08:50 PM.